Power Quality Solutions | 615-244-2825

Home

Bonitron > Products > Line Side

Highlights

Avoid costly power factor penalties
Reduce electrical noise
Reduce risk of damage to sensitive electronics

12 & 18 Pulse Kits
Filtering
Noise/Transient Suppression
Power Factor Correction

	M3713SC 3-Phase DC Bus Supply with Pre-charge	The M3713 is a non-regenerative 3-phase power supply for use as the main power supply for a common DC bus drive system. The drives can be either servo or variable frequency drives intended for use in common bus systems. The M3713 has a selectable start-up current limit which is rated at approximately 20% of the full load rating for pre-charging the VFD bus. The M3713SC includes precharge.
	12 or 18 Pulse Solution VFD or Servo Drives

	M3464 PWM to Sine Wave Filter	Variable frequency AC drives use high frequency switching to control motor speeds. This switching can cause ringing and reflected waves in the cables between the drive and motor, exposing the motor to voltage spikes that can cause motor overheating, or damage the motor’s winding insulation and cause premature failure. The M3464 Sine Wave Filter conditions the AC drives output to a pure sine wave, allowing the motor to run within its design specs, and give the most service life.
	Increase Motor Life
	M3484 Industrial Line Filter	Drives and other valuable equipment can be damaged by line notching from DC drives, capacitor switching transients, slip ring or shoe supply contacts, as well as high order harmonics, making the equipment fail prematurely. The M3484 Line Filter has a tuned filter to protect your installations more effectively than reactors or chokes and a parallel snubbing filter to protect from spikes and notches.
	Protection in harsh electrical environments

	M3517 e-Radicator	The Bonitron e-Radicator is a 120V filter that provides optimal protection for electronics. Most EMI/RFI filters attenuate high frequency noise. However, the e-Radicator adds additional protection for problems caused by frequencies in the 1 KHz to 100 KHz range. These frequencies are particularly generated by rapidly starting and stopping compressors and motors and by phase controllers used in heating, cooling, light dimming, or speed control.
	Noise and Transient Filter Mountable Enclosure
	M3517 e-Radicator II	The Bonitron e-Radicator II, like the e-Radicator, is a 120V filter that provides optimal protection for electronics. The e-Radicator II differs in that it is offered in a stand-alone enclosure, suitable for business or household tabletops, countertops, or shelving.
	Noise and Transient Filter Stand-alone Enclosure
	M3517 e-Radicator VIII	The Bonitron e-Radicator VIII is an 8-plug, 120V filter that provides optimal protection for electronics. Most EMI/RFI filters attenuate high frequency noise. However, the e-Radicator VIII adds additional protection for problems caused by frequencies in the 1 KHz to 100 KHz range. These frequencies are particularly generated by rapidly starting and stopping compressors and motors and by phase controllers used in heating, cooling, light dimming, or speed control.
	Noise and Transient Filter Mountable Enclosure
	M3517 e-Radicator Studio	The Bonitron e-Radicator Studio, like the e-Radicator VIII, is an 8-plug, 120V filter that provides optimal protection for electronics. The e-Radicator Studio differs in that it is specifically designed for use in recording studios to ensure optimal sound, with minimal harmonics and distortion.
	Noise and Transient Filter Stand-alone Enclosure

	Power Factor Correction	With Bonitron’s Power Factor Correction modules, you can put the proper amount of capacitance to minimize the cost and penalties of poor power factor. Installed on your ventilation, pumps, refrigeration, conveyors and fans, Bonitron’s PFC modules will reduce the amount of energy wasted by the motors that drive your business.
	Improve power factor